Gulfcoast Driveshaft 3.5" 1350 Series Aluminum Slip Shaft, Manual Transmission 2015-2017 Ford Mustang GT

Details:

• Driveshaft Diameter: 3.5"
• Driveshaft Material: Aluminum
• Driveshaft Style: One Piece
• Transmission Type: Manual
• Balanced: Yes
• Joint Style: Slip Fit

Features:

• 3.5" x .125" Wall Kaiser KDS4-T8 Aluminum Tubing
• Enhanced Performance Response
• Precision-Balanced Assembly
• 20% Higher Tensile Strength over 6061-T6 Aluminum
• Direct Bolt-On Upgrade
• Hardware Included

Gulfcoast aluminum driveshafts are the ideal way to increase strength and critical speed, whether you're replacing thin wall OE aluminum/steel tubing or converting from a steel two-piece to an aluminum one-piece driveshaft.

Gulfcoast builds each 1350 series driveshaft with 3.5" x .125 wall Kaiser KDS4-T8 aluminum tubing, aluminum bondable yoke shaft and spline sleeve assembly, bond yoke, adapter flange yokes, performance 1350 series solid cross non greaseable u-joints and upgraded hardware for the rear flange. Factory hardware is reused on transmission flange.

Note: 1350 series driveshaft DOES NOT require additional adapters. Gulfcoast builds each driveshaft with aluminum adapter flanges.

Note: Prior to final installation check for any clearance issues. Check the driveshaft tunnel for any bolts, heat shield rub, and exhaust clearance. Any interference with the driveshaft is not covered under warranty.

Part Number: DS-MU1517GTM-35A