Front Strut Tower Brace (2 point) :: 2011-2015 Camaro SS & V6
Eliminate strut tower flex under hard cornering. Additionally, driving over off-camber transitions and other road irregularities can cause the strut towers to distort, reducing front end stability. #STB017
Sale Price: $169.95
You save $10.00!
Chassis Max Strut Brace :: Fits 2010-2011 Camaro
Like most street driven cars, the Camaro suffers from chassis flex. Under hard cornering and when driving over uneven surfaces the unsupported strut towers momentarily distort, reducing stability and control. The new Chassis Max Strut Tower Brace from Hotchkis Performance adds necessary rigidity to the Camaro by eliminating strut tower flex. #20109
Sale Price: $274.95
You save $41.30!
Chromoly Frame (Floor Brace) :: Fits all 2010-2015 Camaro models
Increase your Camaro's chassis strength and reduce flex with American Racing Headers' chromoly brace. Designed to fit both convertibles and hardtop coupes, it also provides the benefit of allowing 3" exhaust on convertibles. TIG welded and powdercoated for long lasting quality and durability. #ARH-Chromoly-Brace
Sale Price: $469.95
You save $25.05!
Driveshaft Tunnel Brace :: 2010-2013 Camaro
Strengthen the floor pan and driveshaft tunnel in your new Camaro. Powdercoated black. Allows you to run a 3" exhaust without any modifications! #HALO-CAMARO-TUNNEL-BRACE
Sale Price: $94.95
You save $5.00!
End Link Mounting Brace, Rear Lower Control Arm :: Fits all 2010-2011 Camaro models
The sway bar tabs on the OE control arm have proven to be failure-prone when stiffer aftermarket sway bars are installed. The nature of the design itself along with the thin OE material just cannot withstand the additional loading created from higher rate sway bars. BMR has a simple bolt-in solution that not only resolves this issue but can be installed in 45 minutes or less! #ELK009
Sale Price: $39.95
You save $15.00!
Strut Tower Brace :: Fits all 2010-2013 Camaro models
Unlike other braces, this fits both V6 & V8 and ALL model years 2010+ and is designed so the brace can later be removed without having to drop the struts. Simply drill 3 holes in each tower, slide in their retainer plate and bolt it down. CNC cut brackets are fully TIG welded to the dual 10ga. steel tubes. No cheap plastic here – Fully CNC machined caps with built in O-rings finish off the look. Tighten up your suspension & make it look even better at the same time. #HALO-CAMARO-STRUT-TOWER-BRAC
Sale Price: $298.95
You save $16.00!