aFe Power Magnum FORCE Stage-2 Cold Air Intake System w/Pro 5R Filters, Dry 2020-2024 C8 Corvette

Features:

• Dyno-Proven Gains up to +12 HP and +10 Lbs. x Ft. TQ
• Outflows Factory Intake by 15%
• Measured Flow: 605 CFM @ 7" H20
• Dyno-Tuned Intake Tube to Achieve Maximum Power Gains
• Dual 360-degree radial flow performance air filters
• Heat resistant housing that enclosed the dual air filter set up
• Housing seals to the trunk cover to protect air filters from unwanted engine heat
• Premium silicone couplings and hardware

Large Five Layer Performance Air Filters:
Dual 4” Flange 360-degree radial flow air filters feature our pre-oiled Pro 5R media with five layers of progressively finer cotton gauze media for maximum performance. They provide your engine with the largest amount of high-flowing air, and in most cases deliver the highest power gains of our filter media options. This media is perfect for street and/or track use. Their inverted tops make for more filter surface area, resulting in longer service intervals.

Heat-Resistant Housing:
The dual air filters are surrounded by an open-element XLPE (cross-linked polyethylene) polymer housing that minimizes warm engine air for maximum performance. It is precisely designed and manufactured to fit perfectly into the factory mounting location. The housing connects to the factory air inlets on each side of the vehicle to capture the coolest air available. Silicone bellow couplings are used for engine movement and easy installation. All the factory harness and mounts are transferred to the back of the aFe POWER housing for a factory-like installation. The radio antenna plastic melded on the factory air box is also transferred to the aFe POWER housing. The removal of the antenna from the factory air box requires two plastic melted mounting tabs to be cut off.

Dyno-Tuned Intake Tube:
This system features a high-quality, computer-designed, dyno-tuned intake tube to achieve maximum power gains while maintaining a perfect fit. The XLPE material is heat soak resistant and extremely durable.

Seals to the Trunk Cover:
The seal trim installed on the housing edge seals to the plastic trunk cover to protect the air filters from unwanted warm engine air. This setup allows for more aggressive air intake noise while not sacrificing any performance.

Premium Hardware:
Premium stainless-steel clamps and flexible silicone couplings are used for strength and durability while also providing the most secure installation available.

Emissions Disclaimer:
This product is not currently CARB exempt and is not available for purchase in California or for use on any vehicle registered with the California Department of Motor Vehicles.

Part Number: 54-13055D