Gulfcoast Driveshaft 3.5" 1350 Series Aluminum Slip Shaft, Automatic Transmission - DS-MU1822GTA-35A 2018-2026 Ford Mustang GT & Dark Horse

Details:

• 3.5" Diameter One Piece Driveshaft
• 2024 Aluminum Yoke Shaft
• Designed for Automatic Transmission
• Slip Fit Joint
• Upgraded Performance U-Joints
• Direct Bolt-On Adapter Flanges
• Balanced (Includes Balance Report Sheet)
• Hardware Included

Important Drivetrain Compatibility Notice

• Alignment Precision Required: Replacing a factory two-piece driveshaft with a rigid one-piece shaft removes the OEM rubber dampeners, instantly amplifying any pre-existing misalignments, worn subframe bushings, or minor flange runout in your vehicle's chassis.
• Return Policy: Post-installation vibrations are a symptom of your vehicle's unique drivetrain angles or bushing deflection, not a defect in the driveshaft itself; returns or warranty claims will not be accepted for installation-related vibrations or vehicle-side alignment issues.

Gulfcoast aluminum driveshafts are the ideal way to increase strength and critical speed, whether you're replacing thin wall OE aluminum/steel tubing or converting from a steel two-piece to an aluminum one-piece driveshaft.

Gulfcoast builds each 1350 series driveshaft with 3.5" x .125 wall Kaiser KDS4-T8 aluminum tubing, aluminum bondable yoke shaft and spline sleeve assembly, bond yoke, adapter flange yokes, performance 1350 series solid cross non greaseable u-joints and upgraded hardware for the rear flange. Factory hardware is reused on transmission flange.

Note: 1350 series driveshaft DOES NOT require additional adapters. Gulfcoast builds each driveshaft with aluminum adapter flanges.

Note: Prior to final installation check for any clearance issues. Check the driveshaft tunnel for any bolts, heat shield rub, and exhaust clearance. Any interference with the driveshaft is not covered under warranty.

Part Number: DS-MU1822GTA-35A