Paragon 1" Lowering Springs 2023-2025 C8 Corvette Z06

Features:

• Fits all C8 Corvettes - (Z06/Z07)
• Smooth ride
• Mag Ride functions like factory
• Front Lift still functions like factory
• 1" Lowering Spring
• 30% stiffness increase over Z06 stock
• 11% Stiffness increase over Z07 Springs
• 922 lbs/in Front Spring Rate - Linear
• 576 lbs/in Rear Spring Rate - Progressive
• Powder Coated Black for OEM like look
• Fatigue tested 140,000 jounce to rebound cycles with no issues
• Z06 can achieve a 2 inch drop if they choose via OEM lowering spring perch or by using our lowering collars for front lift cars
• Made in the USA
• Lifetime Warranty
• Works with Paragon Z06 Front Lift Collars
• Works with Paragon 15mm Wheel Spacers

By starting work early on with Hyperco, Paragon Performance helped create a lowering spring option for the C8 Corvette Z06 cars with Mag Ride, and with or without front lift.

*LOWERS 1 INCH ON ALL C8 CORVETTE Z06's

The lowering spring kit offers 1 inch of lowering front and rear. Combine that with the factory adjust-ability of .75 inch lowering you can achieve a total lowering of 1.75-2 inches. The spring is also 30% stiffer than factory giving increased handling without sacrificing low speed ride comfort. Cars that have front lift can use these springs and our lowering collars up front to achieve the same drop.

These have been specifically engineered to work with the factory shocks. Using 3D scanning technology, the entire suspension was scanned, measured, and studied. This resulted in a spring that works with the factory shocks to maintain correct geometries while lowering the vehicle and increasing handling. Anything beyond what these springs offer would require an entire new set up, much like aftermarket coilovers.

Mag Ride Socket

This socket is more than likely needed for your install. Some shops may have this socket already but most people do not as it's a specialty tool. Be sure to watch the install video below to see if you need this or not.

De-Pin Tool

This tool makes de-pinning the connector on mag ride cars much easier. You can still do it without this tool, but be prepared to be frustrated for about 15-20 mins while you fiddle with other small flat heads to try and de-pin the connector.

Collars

The Paragon Front Lift Lowering Collar is for front lift C8 Corvettes and will allow you to lower your car like other Z51 cars that do not have the front lift option. Combined with the factory rear adjustable collars you can achieve the same factory lowering capabilities as other Z51 C8 Corvettes.

Shims

We have added the option for a 3/8" riser shim to be paired with the collars. This will allow people who do not want a full .75" drop to achieve a 3/8" drop. This can be used to fine tune your drop if you have aftermarket springs and want to raise things up a bit or if you just don't want to lower your car the full 3/4".

Note: Works with Paragon Front Lift Lowering Collars and Paragon 15mm Spacers.

Note: Professional installation recommended. Socket and De-Pin Tool recommended for self installation.

Part Number: PP-S0003