Paragon 1" Lowering Springs 2024-2025 C8 Corvette E-Ray

Availability:
- In-Stock
Frequently bought together:
Customer Reviews

The lowering spring kit offers up to 1 inch of lowering front and rear. Combine that with the factory adjust-ability (non front lift cars) of .75 inch lowering you can achieve a total lowering of 1.75-2 inches. The spring is also 30% stiffer than factory giving increased handling without sacrificing low speed ride comfort.
These have been specifically engineered to work with the factory shocks. Using 3D scanning technology, the entire suspension was scanned, measured, and studied. This resulted in a spring that works with the factory shocks to maintain correct geometries while lowering the vehicle and increasing handling. Anything beyond what these springs offer would require an entire new set up, much like aftermarket coilovers.
Mag Ride Socket
This socket is more than likely needed for your install. Some shops may have this socket already but most people do not as it's a specialty tool. Be sure to watch the install video below to see if you need this or not.
De-Pin Tool
This tool makes de-pinning the connector on mag ride cars much easier. You can still do it without this tool, but be prepared to be frustrated for about 15-20 mins while you fiddle with other small flat heads to try and de-pin the connector.
Note: Professional installation recommended. Socket and De-Pin Tool recommended for self installation.
Part Number: PP-S0003
Paragon Performance
Paragon Performance
Paragon Performance
Fabspeed
Fabspeed