BMR Suspension Lowering Springs #SP042 (Front Springs Only) Performance Series
*Fits all 2016-2018 Camaro SS models (does not include rear springs)
Lowers your Camaro approximately .75” in the front
There is nothing like the aggressive look of a car with the right stance! BMR Suspension believes the right springs go beyond looks—your 2016-newer Camaro needs to perform, too! All BMR springs are manufactured from chrome silicon high-tensile spring wire, and are cold wound on a CNC coiling machine. The CNC coiling head can adjust the spring diameter in real time to ensure that every spring is exactly the same. This guarantees that your right spring matches your left spring. Every BMR spring is compressed solid at the factory, not once, but twice. This gives the spring its permanent set, and guarantees no sag. BMR springs are stress-relieved at 750 degrees F, ensuring most stresses induced during the winding process are eliminated. All springs are then shot-peened to eliminate residual surface stresses. Many spring manufacturers skip this step, but BMR insists on this operation as part of our spring manufacturing process. Every spring is computer tested as the last step—every spring, not just a sample from each batch. Each spring is loaded in the spring tester at the factory, then compressed and the CNC load cell measures the force for a variety of spring lengths. This allows BMR to offer a LIFETIME WARRANTY against spring sag.
Blending aesthetics and performance, BMR has designed the SP041 for the street performance crowd who want to use their cars in a variety of application. These springs will lower your Sixth Gen Camaro, and feature a fine-tuned spring rate to give you great handling and a smooth ride. The linear working spring rate offers plenty of support, keeping the body flat and level in the corners, while remaining soft enough for a comfortable ride on any road. When performance and looks are a must, rely on BMR Suspension!
BMR Suspension’s SP042 lowering springs are available in red powdercoat for long-lasting good looks. Installation time is about 2-3 hours. Proudly made in the U.S.A.
***NOTE: This product was not engineered for a V-6 or 4-Cylinder Camaros, nor has it been tested on them.***
Designed to fit 2016-Newer V8 Chevrolet Camaro
Drops your Camaro approximately .75” in the front
Improves handling and ride quality
Manufactured from chrome silicon high-tensile spring wire
Cold wound on a CNC Coiling Machine to exact specifications
Lifetime warranty against spring sag
Stress-relieved at 750 degrees F
Computer tested for accurate height and spring rate
Designed in the U.S.A.
Made in the U.S.A.